ESP-WROVER-KIT – 4MB PSRAM & Flash with TFT LCD, JTAG, ESP32-WROVER Module

-6%

ESP-WROVER-KIT – 4MB PSRAM & Flash with TFT LCD, JTAG, ESP32-WROVER Module

$50.00 $47.00

The ESP-WROVER-KIT is a newly-launched development board built around ESP32. This board is compatible with ESP32 modules, including the ESP-WROOM-32 and ESP32-
WROVER. The ESP-WROVER-KIT features support for an LCD and MicroSD card. The I/O pins have been led out from the ESP32 module for easy extension. The board carries an
advanced multi-protocol USB bridge (the FTDI FT2232HL), enabling developers to use JTAG directly to debug the ESP32 through the USB interface. The development board
makes secondary development easy and cost-effective.

Available on backorder

SKU: ESP32-B008 Categories: , Tags: , ,
  • Description
  • Additional Information
  • Reviews (0)
  • Tutorial

Product Description

ESP-WROVER-KIT – 4MB PSRAM & Flash with TFT LCD, JTAG, ESP32-WROVER Module

Overview of ESP-WROVER-KIT

The ESP-WROVER-KIT is a newly-launched development board built around ESP32. This board is compatible with ESP32 modules, including the ESP-WROOM-32 and ESP32-
WROVER. The ESP-WROVER-KIT features support for an LCD and MicroSD card. The I/O pins have been led out from the ESP32 module for easy extension. The board carries an
advanced multi-protocol USB bridge (the FTDI FT2232HL), enabling developers to use JTAG directly to debug the ESP32 through the USB interface. The development board
makes secondary development easy and cost-effective.

Features

  • ESP32-WROVER module with 4MB PSBRAM, 4MB FLASH
  • 3.2″ TFT LCD display
  • MicroSD card connector
  • Micro USB connector
  • Built-in JTAG and UART interface FTDI FT2232HL
  • RGB LED
  • Two buttons
  • JTAG connector
  • IO 48 pin 0.1″ step connector
  • 5V power supply jack
  • ON/OFF switch

The kit can be powered by either the microUSB port or the external DC power jack. The desired power source must be selected by shorting the proper jumper (shown in the following images). The FT2323 chip will appear as 2 separate serial interfaces when the board is plugged in to your computer. Only one will be usable as the UART for programming the ESP32 on board. When using the IO extender ports, make sure to return the IO signal to ground by using the nearest available ground pin.

To use a feature, be it the in-built LDO, the UART for programming or even the JTAG interface, they must be enabled by shorting the required jumpers. None is enabled by default without using jumpers. The EN and IO0 lines on the board are automatically controlled and thus there is no need to set the board to boot mode before using the flashing tool. However, the board may need to be reset by using the EN button after programming.

ESP-WROVER-KIT Schematic

ESP-PSRAM32 DataSheet

Additional Information

Weight 0.050 kg
Dimensions 51 x 52 x 5 mm
Color

Green

Reviews

There are no reviews yet.


Only logged in customers who have purchased this product may leave a review.

TBD